1.5kw Hydro turbine
Model No: | XJ25-1.5DCT4-Z |
Output/Power: | 1.5 kw |
Rated Head: | 18 – 25 Meters |
Rated Flow: | 8 – 10 (l/s) |
- Technical Specifications
- Micro hydro generator
- Contact Us Now
Main Parameters of 1.5kw Hydro Turbine | ||||
No. | Items | Parameters | Remarks | |
1 | Model | XJ25-1.5DCT4-Z | Single Nozzle
Turgo Turbine |
|
2 | Rated Head | 18–25 | (meters) | |
3 | Rated Flow | 8–10 | (l/s) | |
4 | Output | 1500 | (W) | |
5 | Efficiency | 70 | (%) | |
6 | Pipe Diameter | 125 | (mm) | |
Generator | ||||
No. | Items | Parameters | Remarks | |
1 | Model | SF1.5-4 | Permanent Magnet Generator | |
2 | Style | PMG | ||
3 | Output | 1500 | (W) | |
4 | Voltage | 230 or 110 | (V) | |
5 | Current | 6.52 | (A) | |
6 | Frequency | 50 or 60 | (HZ) | |
7 | Rotary Speed | 1500 | (RPM) | |
8 | Phase | Single | (Phase) | |
9 | Power Factor | 1.0 | ||
10 | Altitude | ≤3000 | (meters) | |
11 | Insulation Grade | B / B | ||
12 | Protection Grade | IP44 | ||
13 | Temperature | -25~+50 | ℃ | |
14 | Relative Humidity | ≤90 | % | |
Control Box / Control Panel | ||||
No. | Items | Parameters | Remarks | |
1 | Model | WY1.5-1 | ||
2 | Safety Protection | Short circuit Protection | ||
3 | Insulation Protection | |||
4 | Over Load Protection | |||
5 | Grounding Fault Protection | |||
Packing | ||||
No. | Items | Parameters | Remarks | |
1 | Packing Material | Fiberboard | ||
2 | Packing Size | 75×44×52 | (CM) | |
4 | Gross Weight | 70 | (KGS) |
1.5kw Hydro Turbine XJ25-1.5DCT4-Z is an AC direct system consisting of a turbine-generator unit producing AC power which is used as needed. That is, it is fed directly to the appliances. No need for a battery and inverter, XJ25-1.5DCT4-Z offers a complete water-to-wire system with an integral Turgo turbine, generator, and valve flow control. Designed to deliver ready-to-use 115V/230V VAC power, it employs a brushless, special rare-earth permanent magnet alternator and therefore has a higher efficiency than an ordinary alternator.
Output voltage and frequency are controlled by the electronic load controller(with ballast). As little as 8 to 10 liter per second (l/s) falling 18-25 meters through a pipe can supply enough power to comfortably run a small household. This machine is compact, easy to install, and requires little maintenance except lubricating the bearing every few months.
Suneco Hydro provides a Small Scale Hydroelectric Power Generator 1.5kw hydro turbine Single Nozzle XJ25-1.5DCT4-Z, with a water head of 20 meters and a flow rate of 11 liters per second, you can generate 1.5kw power.
The micro hydro generator makes use of water to generate electricity. Isn’t it surprising? Now, this electricity just isn’t in watts but in tons of watts. This means that you need to use this state-of-the-artwork generator to energy your total house.
With this technology in hand, you don’t must pay enormous sums of cash on your fuel-stuffing turbines nor you must worry about paying electric bills. You just must feed the generator with some water and it starts working.
It is compact in measurement and is cheap. The micro hydro turbine generator is an ideal solution for those who want ample electrical energy to light up their houses.
OUTPUT IN WATTS against various head and flow
|
|||||
Water head
(meter)
|
Water flow(liter/second)
|
||||
7 liter/sec
|
8 liter/sec
|
9 liter/sec
|
10 liter/sec
|
11 liter/sec
|
|
17
|
357W
|
544W
|
765W
|
850W
|
1028W
|
18
|
378W
|
576W
|
810W
|
900W
|
1089W
|
19
|
399W
|
608W
|
855W
|
950W
|
1150W
|
20
|
420W
|
640W
|
900W
|
1000W
|
1210W
|
21
|
441W
|
672W
|
945W
|
1050W
|
1270W
|
22
|
462W
|
704W
|
990W
|
1100W
|
1331W
|
23
|
483W
|
736W
|
1035W
|
1150W
|
1391W
|
24
|
504W
|
768W
|
1080W
|
1200W
|
1452W
|
25
|
525W
|
800W
|
1125W
|
1250W
|
1500W
|
The small hydro turbine was designed for families in remote areas to produce power for their households easily and inexpensively. These units have been incredibly successful and today thousands are installed throughout the world. These turbines need very little water flow to run efficiently and produce significant power out. The standard configuration uses one nozzle.
Water is collected upstream from the turbine and channeled in a pipe down to the turbine location. At the turbine, the water passes through a nozzle, where it accelerates, strikes the turbine runner, and turns an AC single-phase brushless permanent magnet alternator. An electric load controller is built on the alternator which stabilizes the voltage to 110V or 220V to protect electrical appliances during use. Installation is very simple and explained in the manual. Once installed there are no running costs and maintenance costs are very low.