Micro-hydroelectric/Water Turbine Generator with 750W Output Power and 75mm Penstock Diameter
Model Number: XJ18-0.75DCT4-Z
Key Specifications/Special Features:
•Water head range: 14 to 18m
•Water flow range: 6 to 8L/second
•Power output: 750W
•Voltage: 115 or 230V AC
•Penstock diameter: 75mm
•Water to wire system with integral turbo turbine, generator and valve flow control
•Brushless, special rare-earth permanent magnet alternator
•Higher efficiency than ordinary alternator
•Output voltage and frequency are controlled by the electronic load controller (with ballast)
•Machine is compact, easy to install and requires little maintenance except lubricating the bearing every few months
•Turbo turbine was designed for families in remote areas to produce power for their households easily and inexpensively
•Units have been incredibly successful and today thousands are installed throughout the world
•Turbines need very little water flow to run efficiently and produce significant power out
•Standard configuration uses one nozzle
•Water is collected upstream from the turbine and channeled in a pipe down to the turbine location
•At the turbine, the water passes through a nozzle, where it accelerates, strike the turbine runner and turns a AC single-phase brushless permanent magnet alternator
•Electric load controller is built on the alternator which stabilizes the voltage to 110V or 220V to protect electrical appliances during use
•Installation is very simple and explained in the manual
•Once installed there are no running costs and maintenance costs are very low
•Packing size: 35 x 35 x 53cm
•Weight: 47kg