1.1kw Hydro XJ22-1.1DCT4-Z

1.1kw Hydro turbine

Model No: XJ22-1.1DCT4-Z
Output/Power: 1.1 kw
Rated Head: 16 – 22 Meters
Rated Flow: 8 – 10 (l/s)

Suneco Hydro Provide small hydro XJ22 Series hydro generators. The 1.1kw model is : XJ22-1.1DCT4-Z

Main Parameters of XJ22,1.1 kw hydro power turbine generator, also check 1.1 kw hydro turbine dual nozzle
Water Turbine
No.
Items
Parameters
Remarks
1
Model
XJ22-1.1DCT4-Z
Single Nozzle
Turgo Turbine
2
Rated Head
16–22
(meters)
3
Rated Flow
8–10
(l/s)
4
Output
1100
(W)
5
Efficiency
70
(%)
6
Pipe Diameter
100
(mm)
Generator
No.
Items
Parameters
Remarks
1
Model
SF0.2-4
 Rear Earth Permanent Magnet Generator
2
Style
PMG
3
Output
1100
(W)
4
Voltage
230
(V)
5
Current
4.78
(A)
6
Frequency
50
(HZ)
7
Rotary Speed
1500
(RPM)
8
Phase
Single
(Phase)
9
Power Factor
1.0
10
Altitude
≤3000
(meters)
11
Insulation Grade
B / B
12
Protection Grade
IP44
13
Temperature
-25~+50
14
Relative Humidity
≤90
%
Control Box / Control Panel
No.
Items
Parameters
Remarks
1
Model
WY1.1-1
2
Safety Protection
Short circuit Protection
3
Islanding Protection
4
Over Load Protection
5
Grounding Fault Protection
Packing
No.
Items
Parameters
Remarks
1
Packing Material
Fiberboard
2
Packing Size
75×44×52
(CM)
3
Net Weight
18
(KGS)
4
Gross Weight
65
(KGS)

Note: The modification of XJ22 – 1.1DCT4-Z appearance or technical parameters, which is a result of technique improvement, will not be announced additionally.

hydro power wiring diagram

1.1KW power curve

Water is collected upstream from the turbine and channeled in a pipe down to the turbine location. At the turbine, the water passes through a nozzle, where it accelerates, strikes the turbine runner, and turns an AC single-phase brushless permanent magnet alternator. An electric load controller is built on the alternator which stabilizes the voltage to 110V or 220V to protect electrical appliances during use. Installation is very simple and explained in the manual. Once installed the small hydro generator there are no running costs and maintenance costs are very low.

If you feel you may have a suitable site, please email specific information on your actual site. The information that is required for a preliminary assessment is:
1. The volume of water flowing in your stream, expressed as liters per second.
2. The head (height of drop) of the falling water, expressed in meters.
3. The length of the penstock (pipeline) in meters.

Local Team Installation Support on 1.1kw hydro power turbine

Listen to What Our Clients Say About Our Hydro Power Turbines!

Request a Quick Quote